• AKAForums.ru

    Русскоязычная версия форума (требуется отдельная регистрация).
    Все о металлоипоиске с детекторами АКА на русском языке!

Signum MFD/MFT Modification "Pro"

Discussion in 'Signum MFD/MFT Modification "Pro"' started by SuchMuch, Feb 2, 2017.

  1. SuchMuch

    SuchMuch Administrator Staff Member

    Messages:
    6,103
    Gender:
    Male
    Local Time:
    2:21 AM
    First Name:
    Rodion
    Sorex:
    Pro (1.00) Ultra
    There is a hardware modification could be installed/added to Signum MFT, Signum MFD.

    Brief description of upgrade:
    - A number of condensers changed
    - A-Gain (Analogue Gain) installed
    - Amperage Trigger installed
    - Additional water resistant gasket is installed over switch on/off button

    Above changes could improve main parameters of stock models, make them more flexible in setting and more precise in GBing and finally to set more sensitivity without falsing to compare with the stock detector.

    Upgrade is available in classifieds section: Signum MFT-MFD with upgrade
     
    Last edited: Feb 1, 2019
    messor likes this.
  2. vint1

    vint1 AKA Master Supporter

    Messages:
    1,384
    Gender:
    Male
    Local Time:
    12:21 AM
    First Name:
    Vinny
    Sorex:
    Pro (1.00)
    I'm a bit confused , with this upgrade , will this mod mprove the performance of the Mfd, and how ? , to me it seems more expense, and why if this upgrade is a improvement , why doesn't aka install it from the start , this is starting to get expensive and confusing . Vinny
     
    Tragac likes this.
  3. TS
    TS
    SuchMuch

    SuchMuch Administrator Staff Member

    Messages:
    6,103
    Gender:
    Male
    Local Time:
    2:21 AM
    First Name:
    Rodion
    Sorex:
    Pro (1.00) Ultra
    This is an overview of subject upgrade (Russian language):


    Air test 70-75 cms on 5 kopecks USSR, 15"@3 kHz:

    I suppose trigger was set on maxi (check thread "Trigger Positions and Amperages") and A-Gain was set on higher

    Separation of targets:


    Speed of separation:


    Total control of Signum's power output:


    Above 3 vids are done with A-Gain set on lower and trigger set on mini.

    Signum Pro 3F: Test on Separation


    To sum all up, mod "Pro" makes Signum more flexible and allows to set it running at the edge. More power could be added on clean sites, less power on bad grounds and trashy sites
     
    Last edited: Feb 1, 2019
  4. vint1

    vint1 AKA Master Supporter

    Messages:
    1,384
    Gender:
    Male
    Local Time:
    12:21 AM
    First Name:
    Vinny
    Sorex:
    Pro (1.00)
    Looks ,worth having such . Thanks , i wish I could understand Russian lol
     
  5. TS
    TS
    SuchMuch

    SuchMuch Administrator Staff Member

    Messages:
    6,103
    Gender:
    Male
    Local Time:
    2:21 AM
    First Name:
    Rodion
    Sorex:
    Pro (1.00) Ultra
    There is a further development of the upgrade: 3F.
    "3" means third version of an upgrade, "F" means "Fast".
    Signum with mod Pro ver. 3F is faster (sharper) in target separation.
    3F is already available.
     
  6. vint1

    vint1 AKA Master Supporter

    Messages:
    1,384
    Gender:
    Male
    Local Time:
    12:21 AM
    First Name:
    Vinny
    Sorex:
    Pro (1.00)
    Nice such , who can do this upgrade ?
     
  7. TS
    TS
    SuchMuch

    SuchMuch Administrator Staff Member

    Messages:
    6,103
    Gender:
    Male
    Local Time:
    2:21 AM
    First Name:
    Rodion
    Sorex:
    Pro (1.00) Ultra
    As always section "Classifieds" ;)
     
    Last edited: Feb 1, 2019
  8. Rew

    Rew Moderator Staff Member Supporter

    Messages:
    2,113
    Gender:
    Male
    Local Time:
    12:21 AM
    With these added features, this sounds like a pro machine. I like what I'm seeing and reading.
     
  9. TS
    TS
    SuchMuch

    SuchMuch Administrator Staff Member

    Messages:
    6,103
    Gender:
    Male
    Local Time:
    2:21 AM
    First Name:
    Rodion
    Sorex:
    Pro (1.00) Ultra
    Pls be informed upgrade ver. 4 is being worked on, it's a further development of upgrade ver. 3F (almost 3F, but switchable: detectorist will be able to switch mode "F" on and off)
     
  10. TS
    TS
    SuchMuch

    SuchMuch Administrator Staff Member

    Messages:
    6,103
    Gender:
    Male
    Local Time:
    2:21 AM
    First Name:
    Rodion
    Sorex:
    Pro (1.00) Ultra
    There will 4 speeds of "reactivity"
     
  11. Rew

    Rew Moderator Staff Member Supporter

    Messages:
    2,113
    Gender:
    Male
    Local Time:
    12:21 AM
    That's a very good addition to have.
     
  12. TS
    TS
    SuchMuch

    SuchMuch Administrator Staff Member

    Messages:
    6,103
    Gender:
    Male
    Local Time:
    2:21 AM
    First Name:
    Rodion
    Sorex:
    Pro (1.00) Ultra
    Nowadays the latest version of upgrade is 3F. As it was reported earlier "F" means "Fast". @asgo is working on upgrade version 4.0 .

    New version 4.0 will have adjustable "Reactivity" on board. "Reactivity" is a metal detector's ability to restore after the last signal, this new function will control the speed of restoration.

    asgo:
    ***qte***
    We decided to make 3 step Reactivity:
    1. Fast.
    2. Normal (equal to stock Signum).
    3. Slowed. It's 4 times slower than stock Signum (Slowed mode could be used on light grounds in low-motion hunting)
    ***unqte***
     
  13. tibko

    tibko AKA Novice

    Messages:
    96
    Gender:
    Male
    Local Time:
    1:21 AM
    Berkut-5:
    Restyled (5.20)
    What is the difference between the standard upgrade of older MFDs and new detectors on shop - Signum MFD Pro V4?
     
    SuchMuch likes this.
  14. TS
    TS
    SuchMuch

    SuchMuch Administrator Staff Member

    Messages:
    6,103
    Gender:
    Male
    Local Time:
    2:21 AM
    First Name:
    Rodion
    Sorex:
    Pro (1.00) Ultra
    As far as I know, there is a "Fast" mode (hardware setting) added that controls speed of detector and components turned to a particular detector in order to reduce internal "noise".

    Better ask @asgo directly
     
  15. asgo

    asgo Authorized AKA Modder & Dealer

    Messages:
    82
    Gender:
    Male
    Local Time:
    2:21 AM
    First Name:
    Sergey
    Intronik:
    STF
    Hallo, Tibor! it is not difference if it realy legal Signum PRO V4, becouse last time appears a lot of fake upgrades/ Very bad quality. I f you have not posibility to by it from me and want to by it in your cointry, mail me the number of it, i ll check it in my data base. I mean if you do the upgrade of 4 ver. And if we compare the previous version (3 ver.) it is a great difference.
    1 The 4 version has trigger to change speed of recovery (like SAT in Spectra)
    2 And the main thing - in 3 version we only change the coponents, but in 4 version we do the individual tuning of every device to calibrate it to very high standarts, It is instrumental control. For example - voltage variation in the circuits. So the 4 ver. is more stable than 3.